Ten years of cumulative precipitation

Ten years of cumulative precipitation

January 28, 2013 to Mapping by Nathan Yau
We've all seen rain maps for a sliver of time. Screw that. I want to see the total amount of rainfall over a ten-year period. Bill Wheaton did just that in the video above, showing cumulative rainfall between 1960 and 1970. The cool part is that you see mountains appear, but they're not actually mapped.  Source on FlowingData
The hillshaded terrain (the growing hills and mountains) is based on the rainfall data, not on actual physical topography. In other words, hills and mountains are formed by the rainfall distribution itself and grow as the accumulated precipitation grows. High mountains and sharp edges occur where the distribution of precipitation varies substantially across short distances. Wide, broad plains and low hills are formed when the distribution of rainfall is relatively even across the landscape.
See also Wheaton's video that shows four years of rain straight up.
Is there more recent data? It could be an interesting complement to the drought maps we saw a few months ago. [Thanks, Bill]

Comments

Post a Comment

Popular posts from this blog

Orifice and Weir flow calculations

Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e., the fraction opened) changes, flow coefficients for both orifice and weir behavior are computed as follows: a. For side orifices: Define Hcrit = h/2 where h is the opening height. b. For bottom orifices: i. For a circular orifice, compute area over length (i.e., circumference) as AL = h /4. ii. For a rectangular orifice compute AL = h*w/(2*(h+w)) where w is the opening width. iii. Compute Hcrit = Cd*AL/0.414 where Cd is the orifice discharge coefficient. At step 1b, the critical head for the bottom orifice, where orifice flow turns into weir flow, is found by equating the result of the orifice equation to that of the weir equation Cd*Area*sqrt(2g)*sqrt(Hcrit) = Cw*Length*sqrt(Hcrit)*Hcrit or Hcrit = (Cd * Area) / (Cw/sqrt(2g) * Length) The value of Cw/sqrt(2g) for a sharp crested weir is 0.414.
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                                                   ERROR 105: cannot open ODE solver.                                                                                              ERROR 107: cannot compute a valid time step.                                                                                     ERROR 108: ambiguous outlet ID name for Subcatchment                                                                            ERROR 109: invalid parameter values for Aquifer                                                                                  ERROR 110: ground elevation is below water table for Subcatchment                                                         
Read more

EMC Washoff in SWMM5

Image
There are four steps to using EMC concentrations in your network: 1. Define your pollutant by adding a pollutant using the Data=>Quality=>Pollutant command : 2. Define the Land Use by using the Data=>Land Uses command or the Land Use Editor: 3. Define Buildup to be None by clicking on the None Tab: 4. Define the EMC Washoff concentration by clicking on the Washoff Tab: This is where you would add a GW concentration More: http://www.swmm2000.com/
Read more