Steps in Using RDII Analyst for InfoSWMM, ICM and InfoSewer

Subject:  Steps in Using RDII Analyst for InfoSWMM, ICM and InfoSewer

Steps in Using RDII Analyst for InfoSWMM, ICM and InfoSewer by dickinsonre Subject:  Steps in Using RDII Analyst for InfoSWMM, ICM and InfoSewer  Step 1: Create a Base UH  in the Operation Tab of the Attribute Browser using RDII Analyst (Figure 1) Step 2: Assign a UH to at Least 1 Node Using the Inflow Icon   Step 3: Open Up RDII Analyst and Click on New to Create a RDII Session     Step 4: Define the Flow and Rainfall File      Step 5: Review the Imported Flow Time Series Step 6: Review the Imported Rainfall  Time Series           Step 7: Units and RDII Analyst Dates are Controlled by the Simulation Manager    Step 8: Extract DWF from the Flow Time Series     Step 9: Assign a UH to at Least 1 Node Using the Inflow Icon   Step 10: View the DWF Pattern          Step 11: Create the RDII Time Series           Step 12: View the RDII Time Series    Step 13: Run Once Feature to See how Good the Current RTK Parameters are in matching the monitored flow Step 14: You can use Graph Control to show the mean of the Observed and Predicted RDII on one Graph.         Step 15: Calibrate the RTK Parameters         Step 16: Run the GA  Step 17: Assign the Intermediate Answers  to the UH      Step 18: View the Calibration Graph   Step 19: Event Identification    Step 20: Assign the Found DWF Pattern      Step 21: Node DWF and RDII Inflow Step 22: 3 RDII UH's Used in the Simulation of the RDII Flows    Figure 1.  RDII Analyst is part of the InfoSWMM or H2OMAP SWMM Suite but the derived RTK parameters can be used in either InfoSWMM, SWMM5, ICM or InfoSewer  via Blogger http://www.swmm5.net/2013/08/steps-in-using-rdii-analyst-for.html