What are the Equations for Weirs in SWMM 5, Part 2?

Subject:   What are the Equations for Weirs in SWMM 5, Part 2?

What are the Equations for Weirs in SWMM 5, Part 2?

by dickinsonre
Subject:   What are the Equations for Weirs in SWMM 5, Part 2?
 There are four types of Weirs in SWMM 5:  Transverse, Sideflow, V Notch and Trapezoidal.   The trapezoidal weir is a combination of the Sideflow and V Notch Weir and the Sideflow acts like a Transverse Weir when the flow is reversed (Figure 1).  The Weirs can have zero, one or two end contractions (Figure 2) and the Weir Length is a function of the Weir Setting and Horizontal Weir Length.  A V Notch weir works as Trapezoidal Weir when the Weir RTC Setting is less than 1.0 
 Figure 1.   Weir Equations in SWMM 5
 Figure 2.   Valid Number of End Contractions
 
Figure 3.  Weir Length Calculations
 

Comments

Post a Comment

Popular posts from this blog

Types of Stormwater Inlets from HEC12 and HEC22

Image
Note :   Types  of  Stormwater   Inlets  from  HEC12  and  HEC22 Stormwater   Inlets  consist of four main  types  ( http://onlinemanuals.txdot.gov/txdotmanuals/hyd/storm_drain_inlets.htm ) with most common shown in Figure 1. 1.    Curb opening  inlets  either at a sag or continuous on the street, 2.    Grate  Inlets  either at a sag or in combination with a Curb opening 3.    Slotted Drains in parking lots which can be simulated as curb opening  inlets  and 4.    Combination  inlets  either at a sag or continuous on the street which combine a curb opening inlet and a grate inlet for the  stormwater  runoff A sag inlet is the end of the line for the runoff because the flow and its debris load have no other place to go as described in the  HEC-22  and  HEC-12  manuals and a continuous grade inlet...
Read more

More St Venant Equations in #SWMM5

Image
This blog shows the relationship between the terms dq1, dq2, dq3 and dq4 in the SWMM5 code and the St. Venant Partial Differential Equations. dq2 = Time Step * Area wtd * (Head Downstream – Head Upstream) / Link Length or dq2 = Time Step * Area wtd * (HGL) / Link Length Qnew = (Qold – dq2 + dq3 + dq4) / ( 1 + dq1) when the force main is full dq3 and dq4 are zero and Qnew = (Qold – dq2) / ( 1 + dq1) The dq4 term in dynamic.c uses the area upstream (a1) and area downstream (a2), the midpoint velocity, the sigma factor (a function of the link Froude number), the link length and the time step or dq4 = Time Step * Velocity * Velocity * (a2 – a1) / Link Length * Sigma the dq3 term in dynamic.c uses the current midpoint area (a function of the midpoint depth), the sigma factor and the midpoint velocity dq3 = 2 * Velocity * ( Amid(current iteration) – Amid (last time step) * Sigma dq1 = Time Step * RoughFactor / Rwtd^1.333 * |Velocity| The weighted area (Awtd) is used in the dq2 term of the St...
Read more