Duluth Minnesota Flooding of June 20, 2012

Subject: Duluth Minnesota Flooding of June 20, 2012

T

Duluth Minnesota Flooding of June 20, 2012

by dickinsonre
Subject: Duluth Minnesota Flooding of June 20, 2012

The images come from this Duluth Link.    Radar Map

A series of "training" thunderstorms that all passed over the same region have dumped 4 - 5 inches of rain over a wide swath of Northern Minnesota overnight and early this morning. Nearly 8 inches of rain fell in the Denfeld area of western Duluth. This is more rain than fell in the city's previous worst flood on record, which occurred August 20, 1972. Major flooding is occurring, and only emergency travel is recommended in the city due to flooded roads. system and the saturated ground cannot take much more rain. According to wunderground's weather historian, Christopher C. Burt, the all-time 24 hour precipitation record for Duluth is 5.79" on 8/22 - 8/23 1978; 4.14" was recordedon Tuesday at the airport.


Water overflows from a storm sewer in Duluth, Minn. on June 20.
Duluth Mayor Don Ness said he would declare a state of emergency after the deluge of up to 9 inches of rain that he said caused extensive damage to the port city of about 86,000.
Bob King/The Duluth News-Tribune/AP


This car fell into a huge sinkhole on Skyline Parkway in Duluth.

Bob King  /  Duluth News Tribune
This damage Wednesday was on Duluth's Olney Street.
Major flooding in Duluth, Minnesota
A serious flood emergency is occurring in Duluth, Minnesota. A series of "training" thunderstorms that all passed over the same region have dumped 4 - 5 inches of rain over a wide swath of Northern Minnesota overnight and early this morning. Nearly 8 inches of rain fell in the Denfeld area of western Duluth. This is more rain than fell in the city's previous worst flood on record, which occurred August 20, 1972. Major flooding is occurring, and only emergency travel is recommended in the city due to flooded roads. system and the saturated ground cannot take much more rain.
According to wunderground's weather historian, Christopher C. Burt, the all-time 24 hour precipitation record for Duluth is 5.79" on 8/22 - 8/23 1978; 4.14" was recorded on Tuesday at the airport.

Figure 4. Radar-estimated rainfall from the Duluth, Minnesota radar.

Comments

Post a Comment

Popular posts from this blog

Orifice and Weir flow calculations

Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e., the fraction opened) changes, flow coefficients for both orifice and weir behavior are computed as follows: a. For side orifices: Define Hcrit = h/2 where h is the opening height. b. For bottom orifices: i. For a circular orifice, compute area over length (i.e., circumference) as AL = h /4. ii. For a rectangular orifice compute AL = h*w/(2*(h+w)) where w is the opening width. iii. Compute Hcrit = Cd*AL/0.414 where Cd is the orifice discharge coefficient. At step 1b, the critical head for the bottom orifice, where orifice flow turns into weir flow, is found by equating the result of the orifice equation to that of the weir equation Cd*Area*sqrt(2g)*sqrt(Hcrit) = Cw*Length*sqrt(Hcrit)*Hcrit or Hcrit = (Cd * Area) / (Cw/sqrt(2g) * Length) The value of Cw/sqrt(2g) for a sharp crested weir is 0.414.
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                                                   ERROR 105: cannot open ODE solver.                                                                                              ERROR 107: cannot compute a valid time step.                                                                                     ERROR 108: ambiguous outlet ID name for Subcatchment                                                                            ERROR 109: invalid parameter values for Aquifer                                                                                  ERROR 110: ground elevation is below water table for Subcatchment                                                         
Read more

EMC Washoff in SWMM5

Image
There are four steps to using EMC concentrations in your network: 1. Define your pollutant by adding a pollutant using the Data=>Quality=>Pollutant command : 2. Define the Land Use by using the Data=>Land Uses command or the Land Use Editor: 3. Define Buildup to be None by clicking on the None Tab: 4. Define the EMC Washoff concentration by clicking on the Washoff Tab: This is where you would add a GW concentration More: http://www.swmm2000.com/
Read more