HOW MOSQUITOES FLY IN RAIN from 3Quarks

HOW MOSQUITOES FLY IN RAIN

Mariel Emrich in Talking Science:
ScreenHunter_05 Jan. 14 21.42Mosquitoes are as adept at flying in rainstorms as under clear skies. But how is that possible? Wouldn’t rain crush a mosquito to the ground since mosquitoes weigh 50 times less than raindrops?
David Hu, an assistant professor of mechanical engineering and biology at the Georgia Institute of Technology, and his graduate research assistantAndrew Dickerson have found that while mosquitoes do get hit by raindrops, they don’t get crushed by them.
Hu discussed their research in a talk at November's APS Division of Fluid Dynamics Meetingthat was entitled “How Mosquitoes Fly in the Rain”.
The researchers measured the impact forces of raindrops on both regular mosquitoes and custom-built mosquito mimics. The mimics were made from small Styrofoam spheres of mosquito-like size and mass. They used high-speed video to capture images of the mosquitoes getting hit with raindrops.
Since the bugs fly so slowly (a maximum of 1 meter per second) compared to the drops (which fall between 5 to 9 meters per second), the mosquitoes cannot react quickly enough for avoidance, and most likely cannot sense the imminent collision.
More here.
Posted by Abbas Raza at 03:42 PM | Permalink 

Comments

Post a Comment

Popular posts from this blog

Orifice and Weir flow calculations

Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e., the fraction opened) changes, flow coefficients for both orifice and weir behavior are computed as follows: a. For side orifices: Define Hcrit = h/2 where h is the opening height. b. For bottom orifices: i. For a circular orifice, compute area over length (i.e., circumference) as AL = h /4. ii. For a rectangular orifice compute AL = h*w/(2*(h+w)) where w is the opening width. iii. Compute Hcrit = Cd*AL/0.414 where Cd is the orifice discharge coefficient. At step 1b, the critical head for the bottom orifice, where orifice flow turns into weir flow, is found by equating the result of the orifice equation to that of the weir equation Cd*Area*sqrt(2g)*sqrt(Hcrit) = Cw*Length*sqrt(Hcrit)*Hcrit or Hcrit = (Cd * Area) / (Cw/sqrt(2g) * Length) The value of Cw/sqrt(2g) for a sharp crested weir is 0.414.
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                                                   ERROR 105: cannot open ODE solver.                                                                                              ERROR 107: cannot compute a valid time step.                                                                                     ERROR 108: ambiguous outlet ID name for Subcatchment                                                                            ERROR 109: invalid parameter values for Aquifer                                                                                  ERROR 110: ground elevation is below water table for Subcatchment                                                         
Read more

EMC Washoff in SWMM5

Image
There are four steps to using EMC concentrations in your network: 1. Define your pollutant by adding a pollutant using the Data=>Quality=>Pollutant command : 2. Define the Land Use by using the Data=>Land Uses command or the Land Use Editor: 3. Define Buildup to be None by clicking on the None Tab: 4. Define the EMC Washoff concentration by clicking on the Washoff Tab: This is where you would add a GW concentration More: http://www.swmm2000.com/
Read more