How do I correct a fatal error resulting in automatic shutdown in ArcMap?

Subject:   How do I correct a fatal error resulting in automatic shutdown in ArcMap?

If you cannot open ArcMap, InfoSewer or InfoSWMM at all and get a fatal Esri error the problem may be the file normal.mxt

“If the startup file in ArcGIS Desktop or component applications (e.g., ArcMap, ArcGlobe, ArcScene) is corrupt, a fatal error can occur. Renaming or deleting the existing startup file will often resolve the error. Once the corrupted startup file is removed, ArcGIS will create a new startup file after the application is launched (http://kb.iu.edu/data/asuv.html).”

To remove the startup file in Windows XP for Arc GIS 10 go to the directory C:\Documents and Settings\Your Name\Application Data\ESRI\Desktop10.0\ArcMap\Templates and delete the file Normal.mxt.   You then reopen Arc Map and the normal.mxt file will be recreated and smaller.  You will have to reset the ArcMap toolbars to better control InfoSewer and InfoSWMM.  

 
 How do I correct a fatal error resulting in automatic shutdown in ArcMap?



Comments

Post a Comment

Popular posts from this blog

Orifice and Weir flow calculations

Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e., the fraction opened) changes, flow coefficients for both orifice and weir behavior are computed as follows: a. For side orifices: Define Hcrit = h/2 where h is the opening height. b. For bottom orifices: i. For a circular orifice, compute area over length (i.e., circumference) as AL = h /4. ii. For a rectangular orifice compute AL = h*w/(2*(h+w)) where w is the opening width. iii. Compute Hcrit = Cd*AL/0.414 where Cd is the orifice discharge coefficient. At step 1b, the critical head for the bottom orifice, where orifice flow turns into weir flow, is found by equating the result of the orifice equation to that of the weir equation Cd*Area*sqrt(2g)*sqrt(Hcrit) = Cw*Length*sqrt(Hcrit)*Hcrit or Hcrit = (Cd * Area) / (Cw/sqrt(2g) * Length) The value of Cw/sqrt(2g) for a sharp crested weir is 0.414.
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                                                   ERROR 105: cannot open ODE solver.                                                                                              ERROR 107: cannot compute a valid time step.                                                                                     ERROR 108: ambiguous outlet ID name for Subcatchment                                                                            ERROR 109: invalid parameter values for Aquifer                                                                                  ERROR 110: ground elevation is below water table for Subcatchment                                                         
Read more

EMC Washoff in SWMM5

Image
There are four steps to using EMC concentrations in your network: 1. Define your pollutant by adding a pollutant using the Data=>Quality=>Pollutant command : 2. Define the Land Use by using the Data=>Land Uses command or the Land Use Editor: 3. Define Buildup to be None by clicking on the None Tab: 4. Define the EMC Washoff concentration by clicking on the Washoff Tab: This is where you would add a GW concentration More: http://www.swmm2000.com/
Read more