InfoSWMM 2D Layer Properties and Mesh ID

Subject:   InfoSWMM 2D Layer Properties and Mesh ID

InfoSWMM 2D Layer Properties and Mesh ID

by dickinsonre
Subject:   InfoSWMM 2D Layer Properties and Mesh ID
You can use the Layer Properties for layers in the Table of Contents to see the Mesh ID and other simulation data for the 2D mesh in InfoSWMM 2D.  The Mesh ID can be seen using the Labels/Label Expression command and if you use an expression you can see the results data as well on the mesh.  The Mesh ID is used as the label as well in the 2D Output modeling report.  The Net Inflow and Net Outflow is by Mesh ID.  In this example, the flow comes out of Node 80408 to Mesh ID 131 and enters the 1D network again at Mesh ID 848.

Comments

Post a Comment

Popular posts from this blog

Types of Stormwater Inlets from HEC12 and HEC22

Image
Note :   Types  of  Stormwater   Inlets  from  HEC12  and  HEC22 Stormwater   Inlets  consist of four main  types  ( http://onlinemanuals.txdot.gov/txdotmanuals/hyd/storm_drain_inlets.htm ) with most common shown in Figure 1. 1.    Curb opening  inlets  either at a sag or continuous on the street, 2.    Grate  Inlets  either at a sag or in combination with a Curb opening 3.    Slotted Drains in parking lots which can be simulated as curb opening  inlets  and 4.    Combination  inlets  either at a sag or continuous on the street which combine a curb opening inlet and a grate inlet for the  stormwater  runoff A sag inlet is the end of the line for the runoff because the flow and its debris load have no other place to go as described in the  HEC-22  and  HEC-12  manuals and a continuous grade inlet...
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                    ...
Read more