The Three Flows in SWMM 5 for a Link

The Three Flows in SWMM 5 for a Link
There are actually three flows computed or used for a link in SWMM 5:
1. The St. Venant Flow equation flow
2. The Upstream Normal Flow Manning’s equation based on the link roughness, slope, upstream cross sectional area and upstream hydraulic Radius,
3. The flow actually used in the model which is either the flow computed from St. Venant or Manning’s equation
The following three links shows how this works in a real model:
· Link 8040 almost always uses the St. Venant Equation because it is dominated by backwater and surcharge
· Link 8100 almost always uses Manning’s equation except at the beginning and end of the simulation,
· Link 1600 is an adverse slope link and it mainly uses the St. Venant equation.
· Flow = the flow actually used during the simulation
· Qdynamic = the flow computed from the St. Venant Equation
· QNormUp = Flow based on Manning's equation at the upstream end of the link.
· QNormDown = Flow based on Manning's equation at the downstream end of the link.


Link 8100 almost always uses Manning’s equation except at the beginning and end of the simulation. The beginning and end of the simulation is when the non linear terms dominant.


Comments

Post a Comment

Popular posts from this blog

Orifice and Weir flow calculations

Note: Orifice and Weir Flow Computations The orifice flow calculation proceeds as follows: 1. Initially and whenever the setting (i.e., the fraction opened) changes, flow coefficients for both orifice and weir behavior are computed as follows: a. For side orifices: Define Hcrit = h/2 where h is the opening height. b. For bottom orifices: i. For a circular orifice, compute area over length (i.e., circumference) as AL = h /4. ii. For a rectangular orifice compute AL = h*w/(2*(h+w)) where w is the opening width. iii. Compute Hcrit = Cd*AL/0.414 where Cd is the orifice discharge coefficient. At step 1b, the critical head for the bottom orifice, where orifice flow turns into weir flow, is found by equating the result of the orifice equation to that of the weir equation Cd*Area*sqrt(2g)*sqrt(Hcrit) = Cw*Length*sqrt(Hcrit)*Hcrit or Hcrit = (Cd * Area) / (Cw/sqrt(2g) * Length) The value of Cw/sqrt(2g) for a sharp crested weir is 0.414.
Read more

SWMM 5 Error Messages

Engine Error Number Description ERROR 101: memory allocation error.                                                                                             ERROR 103: cannot solve KW equations for Link                                                                                   ERROR 105: cannot open ODE solver.                                                                                              ERROR 107: cannot compute a valid time step.                                                                                     ERROR 108: ambiguous outlet ID name for Subcatchment                                                                            ERROR 109: invalid parameter values for Aquifer                                                                                  ERROR 110: ground elevation is below water table for Subcatchment                                                         
Read more

EMC Washoff in SWMM5

Image
There are four steps to using EMC concentrations in your network: 1. Define your pollutant by adding a pollutant using the Data=>Quality=>Pollutant command : 2. Define the Land Use by using the Data=>Land Uses command or the Land Use Editor: 3. Define Buildup to be None by clicking on the None Tab: 4. Define the EMC Washoff concentration by clicking on the Washoff Tab: This is where you would add a GW concentration More: http://www.swmm2000.com/
Read more